Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: sdp1234 on January 01, 2011, 07:48:40 pm
-
Any good ideas for labeling my VVR on the front panel? VVR is too generic and I already have a master volume?
-
I don't know about "good ideas" but there's a lot that could be used like simple plain old watts, output, master, level, power, voltage, total. Then you could put any of them together - master output, output master, power volume, power output, power master, master power, power total, watts level, power level, master level, master voltage, voltage level, voltage power, total power, etc.
-
B+
-
HT Level :smiley:
-
+1 B+ = A+ :laugh:
-
VariWatt - probably already taken tho.
wattchamacallit... :lipsrsealed:
-
Try POLICE CONTROL
-
Since I use Dana Hall's VVR, I call mine "VVR". That has fewer syllables then master volume does.
Having said that, I like the "B+" label also.
With respect, Tubenit
-
How about...
-
B+POWER ?
or better
B+LEVEL ?
Kagliostro
-
Talent
-
Talent
Hey, I need a schematic for that circuit! :grin:
Chip
-
and if it's range was to be influenced by the listener (wife, kids, neighbors, bandmates working on song) it may not go much past 1. :laugh:
-
Talent
Hmmm....funny, that's what I have the first 6 knobs labeled... :laugh: