Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => PC Express and JSchem - Schematics and Layout diagrams => Topic started by: tubenit on June 05, 2013, 05:54:34 am
-
This was based off an unverified schematic of a clone of a well known amp that used EL84's and had reverb. I think this would be kind of a one trick pony but would have a good overdriven tone.
I changed it to 6V6's, added an active FX for delay pedal (instead of reverb) & to be used as the master volume, changed the tone stack and other values such as coupling caps, smoothing caps and the filter cap values in the B+ rail from the original.
With 275-0-275 PT with 150ma ............ & a 330R/10w resistor for power tubes .......
you should be able to use
5Y3GT for 6K6's
5V4 for 6V6's
GZ34 for 5881's
Haven't built it. Just a DRAFT idea, only.
CHECK for ERRORS! Compare layout with schematic. IF there is a difference, go with the schematic.
IF someone builds this, please post a review on the tweaks forum. Thanks!
with respect, Tubenit