Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: TIMBO on December 22, 2013, 12:45:15 am
-
Hi guys, been thinking about this little project for a while.
I would normally build at least a reverb in most of my builds but lately either there hasn't been enough room or it has been a bottom dwelling chassis.
I also would put a passive XF loop in so it was a case of what circuits will work in this case.
For a bit of a challenge and having a Stereo record player chassis with the socket layout of three 7pin and one 9pin I didn't have to look too far.
Typical Fender reverb...
The 9pin 12AX7 reverb driver
One 7pin 6AV6 recovery
One 7pin 6AV6 for the vibrato (per the Fi Sonic amp)
One 7pin 6X4 rectifier tube
Fits perfect :icon_biggrin: