Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => Hoffman Turret and Eyelet Boards => Topic started by: EL34 on July 31, 2014, 10:55:10 am
-
The layout Diagram, Schematic, BOM, Sound clips and build information can be found on the library page here
http://el34world.com/schematics.htm (http://el34world.com/schematics.htm)
Layout and Schematic for the Stout TMB and Stout
http://el34world.com/Hoffman/files/Hoffman_Stout.pdf (http://el34world.com/Hoffman/files/Hoffman_Stout.pdf)
BOM - Parts list for the Stout TMB and Stout
http://el34world.com/Hoffman/files/Hoffman_Stout_BOM.pdf (http://el34world.com/Hoffman/files/Hoffman_Stout_BOM.pdf)
Hoffman Board install instructions (http://el34world.com/Hoffman/instructions.htm)
Hoffman Turret Boards are on this page
http://hoffmanamps.com/MyStore/catalog/TurretBoard.htm (http://hoffmanamps.com/MyStore/catalog/TurretBoard.htm)
The parts list for this build is here
http://hoffmanamps.com/MyStore/catalog/PartsListIndex.htm (http://hoffmanamps.com/MyStore/catalog/PartsListIndex.htm)
Here's a sound clip of the Stout TMB
http://el34world.com/Misc/Music/files/StoutTMBDemo3.mp3 (http://el34world.com/Misc/Music/files/StoutTMBDemo3.mp3)
I updated the Stout PDF file to include a DPDT switch that can switch the extra gain stage On/Off
I also fixed the long standing phase inverter .022 cap error and made it go to new spot
The stout TMB version has Treble, Middle and bass.
I added negative feedback to quiet the stout down and control some of the nasty distortion bits from the original stout circuit
-
I updated the Stout PDF file to include a DPDT switch that can switch the extra gain stage On/Off
-
Here's a Black Stout TMB with lugs installed
-
Here's a video clip of the Stout TMB
The cmarta mic sounded bad on this video clip
Here's a sound clip with a good mic
http://el34world.com/Misc/Music/files/StoutTMBDemo3.mp3 (http://el34world.com/Misc/Music/files/StoutTMBDemo3.mp3)
Hoffman 18 Watt Stout TMB Part 2 (http://www.youtube.com/watch?v=fX-9a2k0WZc#ws)
-
I went ahead and made a face plate for my 18 Watt Stout.
It came out pretty nice.
It's reversed engraved and then white paint was applied to the engravings
Note that I do not make these faceplates for sale
It's a huge amount of time and labor and I am not really set up to make faceplates with my CNC machine
-
I updated the Stout and Stout TMB PDF file with the voltages
-
Here's my Stout TMB and my Plexi 6V6 in cabinets made by Sivergun