Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: hesamadman on February 07, 2015, 07:40:16 pm

Title: Output tranny mounting
Post by: hesamadman on February 07, 2015, 07:40:16 pm

I've gotten in the habbit of sleeving my OT secondary and running the wires on outside of the chassis. My current build is a PC mount so both windings will be in the chassis. I don't know where the best place to mount this would be. Any suggestions?

Title: Re: Output tranny mounting
Post by: HotBluePlates on February 08, 2015, 02:41:41 pm

Far away from the input jack, close to output tube sockets and speaker jack.

Even if it's p.c. board, there's no rule that says you can't have more than 1 board. Manufacturers connect them with ribbon cable, but you can do better with individual stranded-core wire.