Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: copterdoc on February 11, 2015, 04:08:11 pm

Title: Sluckeys Revibe cap question
Post by: copterdoc on February 11, 2015, 04:08:11 pm

I noticed a difference in cap values between the schematics and board layout. It is c60 0.1uF on the original schematic just coming off V1 pin 6 which matches the board layout. But on Sluckeys' redrawn schematic it is shown as 0.022 uF. I'm guessing 0.1uF is correct but just want to make sure. I did a search and downloaded the pdf again to see if it had been corrected already.  Apologies if this has been addressed elsewhere.  Thanks!

Brad

Title: Re: Sluckeys Revibe cap question
Post by: sluckey on February 11, 2015, 06:35:46 pm

Quote

But on Sluckeys' redrawn schematic it is shown as 0.022 uF.

The schematic is wrong. It should be (and is) 0.1µF.

Thanks for catching that. I'll correct the schematic.

Title: Re: Sluckeys Revibe cap question
Post by: copterdoc on February 11, 2015, 07:42:07 pm

Just wanted to make sure I get this right! Thank you for sharing your design.