Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: kagliostro on September 07, 2016, 01:53:47 am

Title: AA764 tremolo circuit physical position on chassis layout - Question about
Post by: kagliostro on September 07, 2016, 01:53:47 am

Building from scratch an amp like the AA764 with tremolo I would like to know if is possible to build the version of AA764 without tremolo

and place the tremolo circuit (tube and a dedicated board for components) a bit far from the principal board (for chassis layout reasons)

I think it is doable, but are there contraindications of any kind doing that ??

(http://phleroyer.e-monsite.com/medias/images/schema-champ-aa764001.jpg)

(http://vibrochamp.org/wp-content/uploads/2011/06/vibrochamp-schematic.jpg)

(http://phleroyer.e-monsite.com/medias/images/layout-champ-aa764001.jpg)

(http://tubeamplifierparts.com/layouts/fender_champ_vibro_aa764_layout.gif)

Thanks

Franco

Title: Re: AA764 tremolo circuit physical position on chassis layout - Question about
Post by: sluckey on September 07, 2016, 09:02:16 am

I think that will be fine.

Title: Re: AA764 tremolo circuit physical position on chassis layout - Question about
Post by: drew on September 07, 2016, 05:03:11 pm

You can look at a thread on ampgarage.com called "tiny wiggle board" (I think) for a layout, if you're not afraid of the "attack page" warning that the site owner still hasn't fixed.

Title: Re: AA764 tremolo circuit physical position on chassis layout - Question about
Post by: kagliostro on September 08, 2016, 05:29:08 am

Many Thanks Steve & Drew

Franco