Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: guitardude57 on January 20, 2017, 03:35:06 pm
-
Howdy all.
I am looking for a supplier, to get a Fender style convenience outlet.
I got one from somewhere... when I did my Bassman 70 into a Dumble build.
Do not know where I got it.
Looking for a 3 pin grounded one.
Redoing a 67 Princeton Reverb, and the owner wants a 3 wire power cord,
and the outlet to match.
This amp is incredibly clean, other than a couple bad caps in the can, and the bias cap shorted,
and the speaker hosed... not any rust or discoloration to the chassis.
The can cap is a Sprague, and the orange and blue banner label is perfect.
I may just rebuild it, and stick it back on there...
Likely will stick a Jensen C10N speaker in it, as those sound better than the Oxford jobby
that was also found in these amps. And in this one... burned VC.
Not even a spiderweb in there... never seen one this clean.
I would place this one in the $2600 on up value...
I mentioned for him to keep the original power cord, for when he sells it.
I will disconnect the ground switch and death cap, and bypass them.
No need to remove them.
Thanks!
-
Like this?
http://www.ebay.com/itm/NEW-OLD-STOCK-Amphenol-160-2N-AC-Power-Socket-for-Fender-Other-Amps-/291981844958?hash=item43fb7961de (http://www.ebay.com/itm/NEW-OLD-STOCK-Amphenol-160-2N-AC-Power-Socket-for-Fender-Other-Amps-/291981844958?hash=item43fb7961de)
-
Hell yes!
Thank you Brother!
-
Those are hard to come by, buy them all. I found a lot of 40 so I grabbed em.