Hoffman Amplifiers Tube Amplifier Forum

Other Stuff => Guitars => Topic started by: davidwpack on October 18, 2017, 01:20:29 am

Title: LP mod
Post by: davidwpack on October 18, 2017, 01:20:29 am

I was thinking of dropping some push/pull pots in my LP for coil splitting. I happened upon the link below while searching for pcb mount pots. Just wondering if anyone has modded their LP with this and what opinions were.
https://reverb.com/item/5426479-new-product-control-pcb-for-epiphone-gibson-les-paul-jimmy-page-mark-1 (http://https://reverb.com/item/5426479-new-product-control-pcb-for-epiphone-gibson-les-paul-jimmy-page-mark-1)

Title: Re: LP mod
Post by: davidwpack on October 18, 2017, 10:29:40 am

My links never work. Copy, paste. Copy, paste. Anyway it's a drop-in replacement pcb for Les Paul. All your pots (included) are push/pull for coil splitting, polarity, and series/parallel. Pickups, jack, and switch plug into the board with no solder. Switches on the board for treble bleed on/off.  I don't think it's that expensive ($130) considering all those options and if it's well-made. Just wondering if anyone has tried it...dave

Title: Re: LP mod
Post by: SILVERGUN on October 18, 2017, 06:52:06 pm

Here's a fixed link for you:
https://reverb.com/item/5426479-new-product-control-pcb-for-epiphone-gibson-les-paul-jimmy-page-mark-1

Title: Re: LP mod
Post by: davidwpack on October 18, 2017, 07:03:04 pm

Ahh. Thank ye!