Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: davidwpack on January 15, 2018, 12:27:03 pm

Title: A reverb question about reverb
Post by: davidwpack on January 15, 2018, 12:27:03 pm

Ello! I feel I should be able to figure this out but I really don't have any previous experience with the reverbs. What is the triangular tab/washer with the little hole for on RCA jacks exactly? I'm not sure if it was intended to be screwed down for extra security to keep the RCA jack from moving or if it's a solder tab or what. It's not depicted on any of the Fender wiring diagrams that I've seen. Or any others for that matter. Just wanna make sure before I make a reverb circuit that doesn't reverb. I feel like my questions are stupid... sorry.. thanks!..dave

Title: Re: A reverb question about reverb
Post by: sluckey on January 15, 2018, 01:08:42 pm

It's the ground lug. I like to bend mine to make connection easier.

Title: Re: A reverb question about reverb
Post by: davidwpack on January 15, 2018, 01:44:56 pm

Ok. Thanks Sluckey!