Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: reddead83 on April 10, 2018, 09:45:56 pm

Title: My Take on Sluckey's Revibe
Post by: reddead83 on April 10, 2018, 09:45:56 pm

Finally finished my Revibe built off Sluckey's. It now works after realizing I connected the output to ground one lug over, oops. Sounds great other than the intensity knob starts to add hum after about 2 up until almost the end of travel. I'll have to figure that out. Thanks Sluckey!

Title: Re: My Take on Sluckey's Revibe
Post by: reddead83 on April 10, 2018, 09:49:21 pm

Front

Title: Re: My Take on Sluckey's Revibe
Post by: sluckey on April 11, 2018, 04:24:42 am

That really looks nice! Inside and out! Gotta get a seafoam Strat now. :wink:

Title: Re: My Take on Sluckey's Revibe
Post by: reddead83 on April 13, 2018, 06:39:41 pm

Thanks for the kind words. Got the seafoam Strat covered  :icon_biggrin:

Title: Re: My Take on Sluckey's Revibe
Post by: Apexelectric on April 22, 2018, 04:35:13 pm

Red,

Who did the face plate? Been looking for someone to do one offs for me.

Title: Re: My Take on Sluckey's Revibe
Post by: reddead83 on April 24, 2018, 12:38:13 am

Mojotone made the faceplate.

Title: Re: My Take on Sluckey's Revibe
Post by: DummyLoad on April 26, 2018, 01:51:28 pm

Quote from: Apexelectric on April 22, 2018, 04:35:13 pm

Red,

Who did the face plate? Been looking for someone to do one offs for me.

give these guys a try: cam expert.


http://www.cam-expert.com/


--pete