Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: vratocaster on October 29, 2020, 09:43:47 pm

Title: Need advice: Help with tube preamp output (pedal)
Post by: vratocaster on October 29, 2020, 09:43:47 pm

Hi guys... I'm starting with a tube preamp pedal based in sluckey marshall  schematic. The output signal will be ok to work with a power amp/power amp in.
My question is: How I can get properly line signal to go from the preamp output to feed pedals? Do I need some pad attenuation? The 1 meg master volume pot will be enough to drive the properly signal level?

Title: Re: Need advice: Help with tube preamp output (pedal)
Post by: sluckey on October 29, 2020, 09:53:06 pm

Probably gonna need a cathode follower after the master volume pot.

Title: Re: Need advice: Help with tube preamp output (pedal)
Post by: vratocaster on October 29, 2020, 10:19:26 pm

Thanks @sluckey! Please give some advice, Wich is better in this case ?  Triode CF or  Mosfet CF?