Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: Joker3 on November 03, 2020, 09:59:28 am

Title: Super Six Reverb
Post by: Joker3 on November 03, 2020, 09:59:28 am

My first post so please excuse any initial stupidity.  I’ve inherited a Super Six, well sort of.  I’ve got the cab, missing most all drivers, and some damage to its grill and tolex.  The chassis has mostly been stripped.  There is a good PT and OT with the choke.  Pots, jacks, circuits stripped out.  So, what to do?  I’m too old to lug a full Super Six around, I’m thinking of getting a twin cab built and running with 2X12s at 4 ohms.  Since the board is already trashed, I could go with some pre-amp choices?  Any help/suggestions much appreciated.  Looks like a ssn of A 41671.  Doc

Title: Re: Super Six Reverb
Post by: vampwizzard on November 03, 2020, 11:53:26 am

I would definitely do something in the Twin realm. 4 6L6's and the twins a little simpler. They used the same OT. 4Ohm total speaker load (parallel two 8ohm's).

Title: Re: Super Six Reverb
Post by: DummyLoad on November 04, 2020, 12:22:09 am

which super six? the 100W pentode mode or 135W UL version?


--pete

Title: Re: Super Six Reverb
Post by: Joker3 on November 04, 2020, 10:45:00 am

No totally sure - CFA7106 on back plate.  It’s been severely stripped, but looks like UL wires on OT are taped over, not cut as are all others OT connections.

Title: Re: Super Six Reverb
Post by: pdf64 on November 04, 2020, 01:11:10 pm

Under the speaker jacks, does it note 100W or 135W?