Hoffman Amplifiers Tube Amplifier Forum

Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: Stuff4bikes on December 26, 2021, 11:40:28 pm

Title: Negative bias pot placement
Post by: Stuff4bikes on December 26, 2021, 11:40:28 pm

Hoffman Princeton reverb clone......

Any problem running wires half way across the chassis.....I would imagine you treat them like any power wire,
Routing them away from all signal?

Title: Re: Negative bias pot placement
Post by: Latole on December 27, 2021, 03:58:28 am

It is mostly DC voltage, no noise. Run wires like you want.
AC are from Power Transformer to the bias circuit rectifier diode. It is the only wire to be "careful"