Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => EZ Board postings => Topic started by: Geezer on June 18, 2005, 05:45:56 am
-
Hoffman Amplifiers
> Tube Amp Building - Tweaks - Repairs
>
<< Prev Topic | Next Topic >>
Author Comment
vinman753
Junior tube assistant
Posts: 102
(3/28/04 11:41 am)
another speaker hookup question
--------------------------------------------------------------------------------
i have a multi tap OP in my diy amp. It's going to have 4 10's in the cab. they are jensen c10q's rated at 8 ohm each.
Will it matter power or soundwise whether i hook them up for a 2 ohm connection (parallel) or 8 ohm (series-parallel)?
thanks.
Tiny Daddy
I will work on all amps
Posts: 577
(3/28/04 2:33 pm)
Re: another speaker hookup question
--------------------------------------------------------------------------------
I think you will get much better results if you hook up for 8 ohms. And momentarily connect a 1.5V battery and watch that the cones all move forward or back together.
<< Prev Topic | Next Topic >>
Topic Commands
Click to receive email notification of replies
jump to: Tube Amp Building - Tweaks - Repairs (New)New Product Suggestions (New)Praises - Complaints - Suggestions (New)Buy - Sell- Trade (New)Archives (New)
- Hoffman Amplifiers - Tube Amp Building - Tweaks - Repairs - Hoffman Amplifiers -
Powered By ezboard® Ver. 7.32
Copyright ©1999-2005 ezboard, Inc.