Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: joesatch on November 12, 2022, 09:20:35 pm
-
i know there is a method where you remove the ground from the middle pot but i want to delete the entire tonestack. I'm running all the tone controls on 10 constantly so i would like to delete the tonestack. How would i get the signal from the cathode follower to the MV pot?
-
One coupling cap directly between cathode and MV pot.
-
All knobs on 10 will not be the same frequency response as deleting the tonestack though. You will get a different sound.
To run everything always on 10, you could replace the pots with fixed resistors of the same value as the pots.
-
All knobs on 10 will not be the same frequency response as deleting the tonestack though. You will get a different sound.
To run everything always on 10, you could replace the pots with fixed resistors of the same value as the pots.
if the controls went to 11 i would have them there so i will delete the tonestack completely. I'll yank the slope resistor and replace the 470pf off the cathode follower with a 22nf running directly to the MV
-
I’d be interested to know what the result sounds like 👍