Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => Tube Amp Building - Tweaks - Repairs => Topic started by: Travis8 on August 02, 2023, 12:30:34 pm
-
Hi,
I´m trying to fix a deluxe reverb, the issue is that turn up the reverb make a lot of hiss, the hiss only come down when I disconnect the reverb tank..
some ideas?
-
Is the TAD 4AB3C1B new one..
-
Also If I remove V4 noise dissapear and If I remove v3 noise still there.
-
I try with a new V4 and the noise continue.
the noise here: https://drive.google.com/file/d/1Tyx-001ATqgZxwEcXtoSo04p8hshFqnC/view?usp=drive_link
-
> deluxe reverb 65
Probably the 1993 Reissue?
https://robrobinette.com/images/Guitar/Deluxe_Models/65_Deluxe_Reverb_RI_Manual.pdf
-
> deluxe reverb 65
Probably the 1993 Reissue?
https://robrobinette.com/images/Guitar/Deluxe_Models/65_Deluxe_Reverb_RI_Manual.pdf
Serial number: AC 075690
-
could be RCA cables?
The tank is very new, I think is correct.
-
Why was the tank replaced?
-
Why was the tank replaced?
Becouse old one doesnt sound and the tremolo doesnt sound too.
Now works but with this noise
-
Try another cable set. OK to borrow from your sound system.
BTW, tremolo issue is likely not related to reverb issue.
-
Try another cable set. OK to borrow from your sound system.
BTW, tremolo issue is likely not related to reverb issue.
Ok, i will try another cables..
Yes, I know tremolo must be another think but I didnt found it yet... tubes are new
-
Also try a snubber cap on the return from the reverb tank like Fender used in the 70's. That's what that cap was there for.
Dave
-
Ok, tremolo was bad footswitch now is working
-
Also try a snubber cap on the return from the reverb tank like Fender used in the 70's. That's what that cap was there for.
Dave
ok, never see it. I will investigate
-
2000pF is the same as .002µF. If cables and/or this cap don't fix this issue you need another tank. It seems like I see lots of issues with new tanks these days.
-
2000pF is the same as .002µF. If cables and/or this cap don't fix this issue you need another tank. It seems like I see lots of issues with new tanks these days.
Ok, I order one good RCA shielded cable to try it, the two 12AT7 are this one "TAD ECC81/12AT7-Cz" could be problematic this tube for reverb?
-
First of all, can you confirm that this amp has already worked perfectly? No hiss?
Secondly, has this amp ever been repaired by another person ?
And finally, show us a good photo of the circuit. I suspect somes wires are misplaced.