Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => EZ Board postings => Topic started by: Geezer on June 18, 2005, 05:55:44 am
-
Hoffman Amplifiers
> Tube Amp Building - Tweaks - Repairs
>
<< Prev Topic | Next Topic >>
Author Comment
johnt1
Junior tube assistant
Posts: 5
(4/1/04 12:23 pm)
I have ? on pot install for revibe unit
--------------------------------------------------------------------------------
Several of the pots for my revibe unit have a small tab on one side. This causes the pot to sit unevenly on the chassis. Should I snap off this tab. If not. How do I get the pot to sit correctly. Also If anyone has some building tips for the revibe unit I am open to suggestions.
Thank you John T.
bnwitt
Senior tube assistant
Posts: 311
(4/1/04 12:34 pm)
Re: I have ? on pot install for revibe unit
--------------------------------------------------------------------------------
snap em off baby!
ganzonimx
Hey get your own solder
Posts: 448
(4/1/04 12:40 pm)
Re: I have ? on pot install for revibe unit
--------------------------------------------------------------------------------
the tab is supposed to hold the pot in place. If you whant to use it, you have to drill a little hole in the chassis were the tap fits. If the tap passes through the chassis, lower it a little ore use washers between the pot and the chassis.
Alot of people snap them off, like Barry - I like to drill the holes, it's your choice...
Cris
<< Prev Topic | Next Topic >>
Topic Commands
Click to receive email notification of replies
jump to: Tube Amp Building - Tweaks - Repairs (New)New Product Suggestions (New)Praises - Complaints - Suggestions (New)Buy - Sell- Trade (New)Archives (New)
- Hoffman Amplifiers - Tube Amp Building - Tweaks - Repairs - Hoffman Amplifiers -
Powered By ezboard® Ver. 7.32
Copyright ©1999-2005 ezboard, Inc.