Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => EZ Board postings => Topic started by: Geezer on June 18, 2005, 06:06:55 am
-
Hoffman Amplifiers
> Tube Amp Building - Tweaks - Repairs
> Matchless Spitfire inputs
<< Prev Topic | Next Topic >>
Author Comment
bluelake boy
Junior tube assistant
Posts: 1
(4/4/04 5:19 am)
Matchless Spitfire inputs
--------------------------------------------------------------------------------
I've noticed that a few forum members have built Matchless Spitfire clones. I have a layout and a schematic, and I noticed the schematic specifies isolated inputs. I am planning to use shielded cable grounded at the input end. Are the isolated inputs necessary? I have switchcraft switching jacks or the old style marshall jacks that Doug sells, on hand. (not too sure about how to wire the marshall jacks) Thanks!
jc
I only work on Fender's
Posts: 695
(4/4/04 7:22 am)
Re: Matchless Spitfire inputs
--------------------------------------------------------------------------------
They will work fine. I used the switchcraft jacks also.
<< Prev Topic | Next Topic >>
Topic Commands
Click to receive email notification of replies
jump to: Tube Amp Building - Tweaks - Repairs (New)New Product Suggestions (New)Praises - Complaints - Suggestions (New)Buy - Sell- Trade (New)Archives (New)
- Hoffman Amplifiers - Tube Amp Building - Tweaks - Repairs - Hoffman Amplifiers -
Powered By ezboard® Ver. 7.32
Copyright ©1999-2005 ezboard, Inc.