Hoffman Amplifiers Tube Amplifier Forum
Amp Stuff => EZ Board postings => Topic started by: Geezer on June 23, 2005, 05:14:24 am
-
Hoffman Amplifiers
> Tube Amp Building - Tweaks - Repairs
> removing chassis rivets
<< Prev Topic | Next Topic >>
Author Comment
Van
Junior tube assistant
Posts: 66
(5/26/05 1:34 pm)
Reply removing chassis rivets
--------------------------------------------------------------------------------
Does anyone know of an easy way to remove chassis rivets ? I've got an old Silvertone chassis that I'd like to build something else in, but the sockets are riveted.
Funkalicousgroove
I only work on tube amps
Posts: 478
(5/26/05 1:43 pm)
Reply Re: removing chassis rivets
--------------------------------------------------------------------------------
Drill through them then crush them with vice grips and push them through-maybe?
Or grind one end off with a dremel
PhatTele
Junior tube assistant
Posts: 64
(5/26/05 1:59 pm)
Reply Re: removing chassis rivets
--------------------------------------------------------------------------------
I drill through them. They usually split apart and are fairly easy to remove. Wear saftey goggles!!...they can blow apart too.
Tiny Daddy
I only work on Fender's
Posts: 1233
(5/26/05 3:15 pm)
Reply Re: removing chassis rivets
--------------------------------------------------------------------------------
If they are ordinary brass rivits I drill them. Usually the rivit starts spinning and won't drill so I use a cordless drill and drill at about 30 degree angle to keep it cutting. Also I am using a 3/16 bit, or 1/8 for smaller rivits so it just drills off the rivit head.
Pop rivits are a different kind of problem and I use a small pin punch, made from a jewlers screwdriver, to knock out the remains of the steel pin before drilling.
ampcabinets
Senior tube assistant
Posts: 158
(5/26/05 5:08 pm)
Reply
Re: removing chassis rivets
--------------------------------------------------------------------------------
I usually use an oversized drill if I can get to them from the inside, drill off just the roll-over and then tap them out.
Van
Junior tube assistant
Posts: 67
(5/26/05 5:27 pm)
Reply RIVETS
--------------------------------------------------------------------------------
On behalf of my o'possum, and myself, I thank you all for your replies.
gehicks
Senior tube assistant
Posts: 140
(5/26/05 10:37 pm)
Reply Re: RIVETS
--------------------------------------------------------------------------------
Damn, I thought I was the only one here with a pet possum!
Van
Junior tube assistant
Posts: 68
(5/27/05 2:12 pm)
Reply Possum rivets
--------------------------------------------------------------------------------
Isn't it comforting to know you're not alone in this cold, cold, cruel world ? Yes... amps and O'possums are an unbeatable combination.
<< Prev Topic | Next Topic >>
Topic Commands
Click to receive email notification of replies
jump to: Tube Amp Building - Tweaks - Repairs (New)New Product Suggestions (New)Praises - Complaints - Suggestions (New)Buy - Sell- Trade (New)Archives (New)
- Hoffman Amplifiers - Tube Amp Building - Tweaks - Repairs - Hoffman Amplifiers -
Powered By ezboard® Ver. 7.32
Copyright ©1999-2005 ezboard, Inc.