Hoffman Amplifiers Tube Amplifier Forum

Other Stuff => Solid State => Topic started by: Jack1962 on June 23, 2010, 11:37:02 am

Title: Schematic needed for a Baldwin Professional Custom
Post by: Jack1962 on June 23, 2010, 11:37:02 am

anyone here know where I can get a diagram for a Baldwin Professional Custom , I haven't been able to locate one on the internet. Thanks in advance for any help ya"ll can give me .


                                                      Rock On

Title: Re: Schematic needed for a Baldwin Professional Custom
Post by: Jack1962 on June 25, 2010, 08:45:02 am

Yea I couldn't find one either  :laugh:
the problem with the customer complained about was low volume , well I found the problem, the footswitch was wedged between the speaker on the left hand sides frame and the paper , not allowwing the speaker to move. the customer didn't even know it had a footswitch  :laugh:

                                                      Rock On

Title: Re: Schematic needed for a Baldwin Professional Custom
Post by: Shrapnel on June 26, 2010, 12:22:55 am

I looked for one for a Lowrey DSA without luck. I found someone who had rebuilt one, emailed him, and he didn't have one available, neither did the Lowery Yahoo group. I almost get the feeling that if it isn't from a Hammond Organ, the schematic is going to be a bit rare.

Title: Re: Schematic needed for a Baldwin Professional Custom
Post by: Shrapnel on July 08, 2010, 03:22:03 am

I think I stumbled on to what you were looking for at http://www.ssguitar.com/index.php?topic=592.0
I'd attach it but even zipping the schems and some notes (pulled from the thread) it is 164K in ZIP or RAR formats. PM me your email addy if you want them (and don't want to register on ssguitar.com)

Title: Re: Schematic needed for a Baldwin Professional Custom
Post by: Satchmoeddie on September 27, 2019, 01:26:18 am

I HAVE IT. It's in Jack Darr's amp book (last printing )