Tektronix 921

[John]

Need the probe for it of course. I see quite a few Tek 100mhz probes available.Will they work fine, even though this is a 15 mgz scope? I should have researched before I bought, I know.

This is the scope. Probably have to scroll down to see it.

http://www.ebay.com/itm/Tektronix-T921-Oscilloscope-/190725109960?_trksid=p2047675.l2557&ssPageName=STRK:MEWNX:IT&nma=true&si=JMkNktU8jiXeiSeHXnuNKPJGCis%3D&orig_cvip=true&rt=nc

Thanks for any advice!

[sluckey]

Any probe will do. You may consider a 1X and a 10X probe.

[John]

Sounds good, thank you! I bet I end up paying more for probes than the scope.

[DummyLoad]

Sounds good, thank you! I bet I end up paying more for probes than the scope.

PM address, i'll ship you one for cost of USPS delivery.

--DL

[John]

Wow, thank you! You guys are da best!

[schoolie]

Funny, I bought the same scope, a few months ago.  If you can get it for $50, it's a no brainer.  I also bought a X100 probe on Ebay for around $30.

[John]

$50 is just about what I paid. I know I won't use it "much" but it will be fun figuring it out.

[eleventeen]

I had one of those, except I think it was a 922, which is probably the dual-channel version. Scope-wise, meaning bandwidth, it's a POS, but for audio, it's just delightfully fine. And small.

[twbranch]

This is what I use. Get 100MHz probes. I think they are $25 and work great with my Tek scope. They sell on ebay too and I think the buy it nows are free shipping.

http://www.avexelectronics.com/