LOWATT DR103 clone power section

[idsnowdog]

I have built a preamp board for a HIWATT DR103 project using this layout https://hiwatt.org/Layouts/Tag2.gif .  I do not need the 50/100 watts of a DR504/DR103 and would like to build a power section under 10 watts.  I realize that 10 watts won’t give me the same ungodly loud clean headroom that HIWATT amplifiers are known for.  But I'm not after cleans.

I scrapped a Hammond S6 organ and my input transformers are AO-26361/A0-26706 and output AO-26656-0.  The organ had two 6V6 output tubes and I would like to use two 6P14P/EL84 or two 6AQ5 output tubes.  I realize the transformers I am using aren't ultralinear or measure up to Partridge specs.  So what power section would be a reasonable alternative?  The Hoffman stout?

[idsnowdog]

I found a schematic and layout for the Trinity Triwatt and that looks like a good candidate.  I would just need to rewire it to use 6AQ5 tubes instead.  I could also use 6V6 tubes but I want to use something cheaper instead.

This is what the KT66 or 6V6 switch section looks like.  If I wanted to eliminate the KT66 switch option how would I wire it? 

[sluckey]

This is what the KT66 or 6V6 switch section looks like.  If I wanted to eliminate the KT66 switch option how would I wire it?

You could start by posting a full schematic and layout.

[idsnowdog]

These are the Triwatt

[idsnowdog]

I found this in the builders guide.  It wasn't labeled but it shows the wiring without the power tube switch.