RELAY CIRCUIT

[TIMBO]

Hi guys, Got a small problem with this circuit, I did not know that when the switch/foot switch is in the open position that the LED is on,I assumed that when the switches are on the relay and led would be on  I was wanting to indicate when the Lead Gain/Lead Master is on.The relay is to hard to get to now to rewire it so i was hoping just to rewire the LED.Thanks

[sluckey]

See attachment... Just put the LED and two 330Rs in parallel with the relay coil. That 22uF cap is not needed.

[TIMBO]

Thanks for the reply Sluckey,but it only kinda works. The led/relay comes on when the switch is on, when the switch is off the led takes about 10sec to fade and the relay will only work when it has faded 

[TIMBO]

Please ignore that last post as i am an idiot  had a bad solder joint on the led. Thanks again for the help

[sluckey]

when the switch is off the led takes about 10sec to fade and the relay will only work when it has faded

Remove that 22µF cap.

[TIMBO]

Done, Thanks