Sluckeys Revibe cap question

[copterdoc]

I noticed a difference in cap values between the schematics and board layout. It is c60 0.1uF on the original schematic just coming off V1 pin 6 which matches the board layout. But on Sluckeys' redrawn schematic it is shown as 0.022 uF. I'm guessing 0.1uF is correct but just want to make sure. I did a search and downloaded the pdf again to see if it had been corrected already.  Apologies if this has been addressed elsewhere.  Thanks!

Brad

[sluckey]

But on Sluckeys' redrawn schematic it is shown as 0.022 uF.

The schematic is wrong. It should be (and is) 0.1µF.

Thanks for catching that. I'll correct the schematic.

[copterdoc]

Just wanted to make sure I get this right! Thank you for sharing your design.