Dinged output transformer

[Fiat_cc]

Hi all.
Having a bad day today. Wood work issues, another noisy build, and generally losing faith. Decided to start a new build only to find when I unpacked the output transformer that the corner is dented.
Is this likely to be an issue? I don’t want to build the whole thing only to find I have problems. Never encountered this in a new transformer.
Cheers,
Reuben

[jim]

If the laminates are dinged then a few may be shorted together.   They are each insulated by a layer of lacquer.  Post a pic.   Jim

[Fiat_cc]

Yes, the laminates are dinged. I wouldn’t be concerned (besides aesthetics) if it were just the bell covers.
I’ve been trying to post o pic off my iPhone, but it has the wrong file extension (jpeg not jpg), and I can’t find a way to change it on my phone.

[jim]

It might not be trash--it will certainly work somewhat.  Check out this link on identifying unknown output transformers before you decide on buying another.  It may be close enough to satisfactory spec......
http://tone-lizard.com/identifying-transformers/  Jim

[Fiat_cc]

It is a brand new transformer, straight out of the box, and the project is for somebody who has requested this to be a display piece with exposed transformers etc. I will have to get another one for this project anyway, but I'm wondering whether it will be acceptable for use in a later project.  it is a Hammond 1760W transformer, for Fender Twin and Bassman 100 style circuits.

[PRR]

That will work fine. (It is not much dinged and the ding is in the corner where flux is low.) Use it.

Yes, if this is supposed to be a ShowPiece with exposed parts, you'll get another transformer and use this one where it won't offend any eyeballs.