9-pin ceramic socket mounting

[Geezer]

  Hoffman Amplifiers
    > Tube Amp Building - Tweaks - Repairs
        > 9-pin ceramic socket mounting      
 
<< Prev Topic | Next Topic >>  
Author  Comment  
jp2396
Junior tube assistant
Posts: 5
(3/20/04 10:19 am)
 9-pin ceramic socket mounting
--------------------------------------------------------------------------------
 I was looking at the 9-pin sockets that I ordered (I'm building the plexi) and cannot figure out how they are held onto the chassis. They do not fit inside of the mounting flange provided with the tube shields. Does anyone have any good up-close pictures of how to do this? Any help is appreciated.
 
jp2396
Junior tube assistant
Posts: 6
(3/20/04 10:25 am)
 Re: 9-pin ceramic socket mounting
--------------------------------------------------------------------------------
 I think that I may have figured this out. The socket just sits on the chassis, then the flange is put over the top of the socket and bolted to the chassis. Is this the correct mounting? TIA.
 
ganzonimx
Hey get your own solder
Posts: 437
(3/20/04 12:29 pm)
 Re: 9-pin ceramic socket mounting
--------------------------------------------------------------------------------
 That's the way you do it...

Cris
 
jp2396
Junior tube assistant
Posts: 7
(3/20/04 12:40 pm)
 Re: 9-pin ceramic socket mounting
--------------------------------------------------------------------------------
 Thanks for the reassurance Chris.
 
 
 << Prev Topic | Next Topic >>

 

 Topic Commands
 Click to receive email notification of replies
  
jump to:  Tube Amp Building - Tweaks - Repairs (New)New Product Suggestions (New)Praises - Complaints - Suggestions (New)Buy - Sell- Trade (New)Archives (New)    
 

- Hoffman Amplifiers - Tube Amp Building - Tweaks - Repairs - Hoffman Amplifiers -



Powered By ezboard® Ver. 7.32
Copyright ©1999-2005 ezboard, Inc.