Welcome To the Hoffman Amplifiers Forum

September 07, 2025, 03:03:34 pm
guest image
Welcome, Guest. Please login or register.
-User Name
-Password



Hoffman Amps Forum image Author Topic: Fender Service Parts List 1  (Read 2542 times)

0 Members and 1 Guest are viewing this topic.

Offline concertamp64

  • Level 1
  • *
  • Posts: 17
  • I love Tube amps
Hoffman Amps Forum image
Fender Service Parts List 1
« on: September 06, 2020, 08:49:10 pm »
Just finished installing the caps and resistors in the Hoffman 'Fender Service Parts List 1' kit on my 64 Fender Concert. I visually checked, rechecked...rechecked again......what's best way to proceed at this point?......any tests I should perform before powering on?....as you can tell I'm new at this....any comments will be greatly appreciated...

Offline sluckey

  • Level 5
  • *******
  • Posts: 5075
    • Sluckey Amps
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #1 on: September 06, 2020, 09:59:37 pm »
What was the state of the amp before you replaced all those caps and resistors?
A schematic, layout, and hi-rez pics are very useful for troubleshooting your amp. Don't wait to be asked. JUST DO IT!

Offline Latole

  • Level 4
  • *****
  • Posts: 2522
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #2 on: September 07, 2020, 03:55:24 am »
1- Remove Power tubes, Power amp ON and read how much negative bias voltage you read on pin 5 ( you should have close to -30 vdc if I'm right, less than -25 vdc check bias circuit)

2- I often use bulb current limiter too. to protect amp in case of short circuit
3- Check if amp have the right fuse

Offline Latole

  • Level 4
  • *****
  • Posts: 2522
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #3 on: September 07, 2020, 03:56:28 am »
What was the state of the amp before you replaced all those caps and resistors?

100 % right.

Offline concertamp64

  • Level 1
  • *
  • Posts: 17
  • I love Tube amps
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #4 on: September 07, 2020, 09:25:47 am »
Thanks for replying.....The amp had all original caps and resistors. Power tubes and 1 or 2 preamp tubes were replaced though the years. It really had no issues....other than to me just didn't sound good any more. The large caps all had blisters.....I am the original owner...bought it new in 1964 in El Dorado Ark.

Offline PRR

  • Level 5
  • *******
  • Posts: 17082
  • Maine USA
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #5 on: September 07, 2020, 02:03:53 pm »
I would suggest a Lamp Limiter just in case there is a wiring or part fault. But basically it "should work".

Offline Latole

  • Level 4
  • *****
  • Posts: 2522
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #6 on: September 07, 2020, 02:10:50 pm »
For good tune-up: Use good contact cleaner on each pot and on tubes's socket, slide tubes few time to clean.

Offline concertamp64

  • Level 1
  • *
  • Posts: 17
  • I love Tube amps
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #7 on: September 08, 2020, 06:47:22 am »
thanks for the replies......I'm building the light bulb current limiter........which wattage light bulb?....internet is all over the place on this question...some say lower wattage offers more protection...others say higher / 250 watts etc. offers more protection....

Offline sluckey

  • Level 5
  • *******
  • Posts: 5075
    • Sluckey Amps
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #8 on: September 08, 2020, 06:53:50 am »
I would use a 60 watt bulb for a 2 x 6L6 amp.
A schematic, layout, and hi-rez pics are very useful for troubleshooting your amp. Don't wait to be asked. JUST DO IT!

Offline EL34

  • Administrator
  • Level 5
  • **********
  • Posts: 10407
  • wooot!
    • Hoffman Amplifiers
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #9 on: September 08, 2020, 07:11:51 am »

Offline concertamp64

  • Level 1
  • *
  • Posts: 17
  • I love Tube amps
Hoffman Amps Forum image
Re: Fender Service Parts List 1
« Reply #10 on: November 13, 2020, 04:18:54 pm »
Got through amp power up with lightbulb limiter ok with no issues.....now need to tackle the bad brittle like tone...I thought the new caps might help...but didn't

 


Choose a link from the
Hoffman Amplifiers parts catalog
Mobile Device
Catalog Link
Yard Sale
Discontinued
Misc. Hardware
What's New Board Building
 Parts
Amp trim
Handles
Lamps
Diodes
Hoffman Turret
 Boards
Channel
Switching
Resistors Fender Eyelet
 Boards
Screws/Nuts
Washers
Jacks/Plugs
Connectors
Misc Eyelet
Boards
Tools
Capacitors Custom Boards
Tubes
Valves
Pots
Knobs
Fuses/Cords Chassis
Tube
Sockets
Switches Wire
Cable


Handy Links
Tube Amp Library
Tube Amp
Schematics library
Design a custom Eyelet or
Turret Board
DIY Layout Creator
File analyzer program
DIY Layout Creator
File library
Transformer Wiring
Diagrams
Hoffmanamps
Facebook page
Hoffman Amplifiers
Discount Program


password