Sans Fx loop wiring change

[daveyajd]

Hello all,

I am building a version of the Friedman Dirty Shirley. The original has a Metro style FX loop installed. I am planning on adding this eventually but not right away.
My question is about the 220k resistor that goes from master lug 3 to the FX loop on/off switch. If I am leaving out the FX would I just connect this to treble lug 2 where the FX would come back in? Or is this resistor used because there is an FX loop and I would just use wire to connect master and treble?


Aaron

[sluckey]

Schematic?

[daveyajd]

Steve sorry I don’t have a schematic. This build is being done entirely by photograph forensics and similar lineage comparisons. 


Aaron

[sluckey]

Then my answer is maybe/probably...   

[daveyajd]

  That’s what I was thinking too!


Aaron