Plate Resistor Type Question

[dragonbat13]

Working on a vintage 1966 ab165 bassman.

Want to try out different type resistors on the plates of the preamp tubes. There's a lot of snap crackle pop going on. Other high voltage resistors will be used but I've decided on those already.

Regarding the plates, I'm planning on using
Koa speer carbon film on the phase invertor and third/shared stages, and a metal film type on the two input stages.

I don't know what brand metal film to use.  I'm thinking either xicon or Vishay.

Any suggestions on all of this?

[sluckey]

I like the ones that Hoffman sells.

[PRR]

> There's a lot of snap crackle pop

You don't need "magic" resistors. Just good ones. Or just not 54+ years old. (We all get a bit of snappy-pop in our fifties; knees, elbows, knuckles.)

[tubeswell]

> There's a lot of snap crackle pop

You don't need "magic" resistors. Just good ones. ...

And clean tight socket pin clamps (and good solder joints)