I have ? on pot install for revibe unit

[Geezer]

  Hoffman Amplifiers
    > Tube Amp Building - Tweaks - Repairs
        >    
 
<< Prev Topic | Next Topic >>  
Author  Comment  
johnt1
Junior tube assistant
Posts: 5
(4/1/04 12:23 pm)
 I have ? on pot install for revibe unit
--------------------------------------------------------------------------------
 Several of the pots for my revibe unit have a small tab on one side. This causes the pot to sit unevenly on the chassis. Should I snap off this tab. If not. How do I get the pot to sit correctly. Also If anyone has some building tips for the revibe unit I am open to suggestions.
Thank you John T.
 
bnwitt
Senior tube assistant
Posts: 311
(4/1/04 12:34 pm)
 Re: I have ? on pot install for revibe unit
--------------------------------------------------------------------------------
 snap em off baby!
 
ganzonimx
Hey get your own solder
Posts: 448
(4/1/04 12:40 pm)
 Re: I have ? on pot install for revibe unit
--------------------------------------------------------------------------------
 the tab is supposed to hold the pot in place. If you whant to use it, you have to drill a little hole in the chassis were the tap fits. If the tap passes through the chassis, lower it a little ore use washers between the pot and the chassis.

Alot of people snap them off, like Barry - I like to drill the holes, it's your choice...

Cris
 
 
 << Prev Topic | Next Topic >>

 

 Topic Commands
 Click to receive email notification of replies
  
jump to:  Tube Amp Building - Tweaks - Repairs (New)New Product Suggestions (New)Praises - Complaints - Suggestions (New)Buy - Sell- Trade (New)Archives (New)    
 

- Hoffman Amplifiers - Tube Amp Building - Tweaks - Repairs - Hoffman Amplifiers -



Powered By ezboard® Ver. 7.32
Copyright ©1999-2005 ezboard, Inc.