Parts not in Doug's catalog

[GuitarPilot65]

Please provide recommendation for where to purchase:

• 2-watt/1-ohm resisters for Fender bias test points
• Ceramic 47pF/1kv capacitor (Fender Vibroberb "Bright" channel)

[tubeswell]

Mouser

[Willabe]

.... 2-watt/1-ohm resisters for Fender bias test points.

1/2w is plenty, you don't need 2w. It's only 1 ohm and very little current is going through.

[EL34]

1/2 watt 1 ohm is watt is used for bias and I stock those here
Resistors-3

I stock 47p/500v caps also here
Capacitors-4

Why do you think you need 2 watt and 1000 volts

[HotBluePlates]

I stock 47p/500v caps also here
Capacitors-4

Why do you think you need ... 1000 volts

On other forums, builders have noted so many recurring problems with "500v silver mica" caps leaking DC even when brand-new, even when applied voltage is well below 500v, that they have switched to using 1kV mica caps for pF values in things like Fender amps.

I have no idea whether this is like JJ octal tubes from 10-15 years ago (which had the too-skinny pins that would lose contact with Pin 5 and go into meltdown), and is a problem that has since been resolved.  But those builders were burned enough times by having to troubleshoot new builds & replace the same 500v silver mica caps that they use only 1kV micas or simply skip to ceramic caps.

[EL34]

Well, I have ceramic 500p 1kv caps on the page above also
FYI, Been selling those same caps for 25+ years
This is the first time I have heard of anyone having an issue with the caps I sell