high low jack question ?

[john_t]

I am about to wire up my ga5 schedule 40 build. I have decided to use two jacks. The diagram/ info here shows the correct wiring for two jacks with ground switch and tip connections. I have one jack G S T and one with ground and tip only. If my input # 2 has only a ground and a tip lug can I put both the jumper wire from tip #1 and my 68K both on the tip lug of the # 2 jack.

I hope some one gets this

[phsyconoodler]

i hope you are using a 1 meg resistor on the high jack.
  If you are,then yes,you can run a wire from one to the next.

[john_t]

phsyconoodler, thanks for the help. Yes I have the 1meg for jack #1. So I just was not sure about putting both on the tip of jack #2 as the info her shows the jumper going to the S lug on jack #2 and the tip out with the 68k, Il just put both on the tip.

Thanks
john